Fisher & Paykel DD24DHTI9N cabinet opening requirements

Questions people ask about the DD24DHTI9N

The answers come only from the manufacturer documents linked on this page and the lookup's three outcomes.

What cabinet opening does the Fisher & Paykel DD24DHTI9N need?

The reviewed manufacturer document lists a minimum cabinet opening of 34 1/4 in high, 23 5/8 in wide and 22 13/16 in deep for the Fisher & Paykel DD24DHTI9N, with a maximum opening height of 36 1/2 in. Each figure links to its source in the table on this page. This record is held for installer review, so the lookup never returns it as an automatic candidate.

Is the DD24DHTI9N a standard 24-inch dishwasher?

Fisher & Paykel places the DD24DHTI9N in the 24-inch category. That label describes the cabinet class, not the cutout: the reviewed minimum opening width is 23 5/8 in, and the appliance body is 23 9/16 in wide. Use the opening requirement, never the label, when you compare it with your cabinet.

Will the DD24DHTI9N fit my opening?

Only your measurements can answer that. Enter the opening's height, width and depth in the lookup; the DD24DHTI9N comes back as a dimensional candidate, an installer-review item or outside the published requirements, and because this record is held for installer review it never appears as an automatic candidate. None of the three outcomes is a fit guarantee: mounting, utilities, floor level, trim, panel weight and door swing stay with the installer.

How tall is the DD24DHTI9N, and is that the opening height?

The manufacturer lists the DD24DHTI9N appliance body at 34 in high. The body height is not the opening requirement: the minimum opening height on record is 34 1/4 in and the maximum is 36 1/2 in. Measure from the finished floor to the counter underside at several points and use the smallest reading.

Why is the DD24DHTI9N held for installer review?

It carries a blocking review gate: Candidate requires installer review of site conditions, utilities, panel or drawer clearance; do not enable automatic fit from this research batch. Body depth is chassis only, excluding custom/pre-finished panels. Cavity depth assumes 3/4-inch panels; surrounding panel gaps and drawer sweep need review. The gate stays visible on this page until the evidence resolves.