Bosch SPE53C55UC cabinet opening requirements

Questions people ask about the SPE53C55UC

The answers come only from the manufacturer documents linked on this page and the lookup's three outcomes.

What cabinet opening does the Bosch SPE53C55UC need?

The reviewed manufacturer document lists a minimum cabinet opening of 32 1/8 in high, 17 3/4 in wide and 24 in deep for the Bosch SPE53C55UC, with a maximum opening height of 34 7/16 in. Each figure links to its source in the table on this page. Its sources were reviewed on 2026-09-14.

Is the SPE53C55UC a standard 18-inch dishwasher?

Bosch places the SPE53C55UC in the 18-inch category. That label describes the cabinet class, not the cutout: the reviewed minimum opening width is 17 3/4 in, and the appliance body is 17 5/8 in wide. Use the opening requirement, never the label, when you compare it with your cabinet.

Will the SPE53C55UC fit my opening?

Only your measurements can answer that. Enter the opening's height, width and depth in the lookup; the SPE53C55UC comes back as a dimensional candidate, an installer-review item or outside the published requirements. None of the three outcomes is a fit guarantee: mounting, utilities, floor level, trim, panel weight and door swing stay with the installer.

How tall is the SPE53C55UC, and is that the opening height?

The manufacturer lists the SPE53C55UC appliance body at 32 1/16 in high. The body height is not the opening requirement: the minimum opening height on record is 32 1/8 in and the maximum is 34 7/16 in. Measure from the finished floor to the counter underside at several points and use the smallest reading.

Why is the SPE53C55UC held for installer review?

It carries installation notes from the review. Use the installation drawing to check the 6-inch corner clearance; it is not the full distance needed in front of an open door. Rear connections route through the adjoining cabinet. The installation instructions show a 2.5 × 3.5-inch service opening; confirm the exact location in the drawing. The spec sheet and installation guide give different minimum cavity dimensions. The automatic shortlist uses the stricter spec-sheet dimensions; smaller openings require installer review. The product page lists 21 2/3-inch depth, the installation guide shows 21 5/8 inches, and the spec drawing shows 24 inches. We retain all three claims and screen at 24 inches. The gate stays visible on this page until the evidence resolves.